Pillow tensiometer PFTL 101AE-2.0KN 3BSE004213R1 Metallurgy/steel processing applications

Pillow tensiometer PFTL 101AE-2.0KN 3BSE004213R1,It is suitable for applications with small tension, heavy roll and high running speed, and there are often many such applications in metallurgy, steel, nonferrous metals, paper making, metal deep processing and other industries.
PFTL 101AE-2.0KN 3BSE004213R1 Pillow block tensiometer horizontal load measuring element, fixed cable connection, force measuring range: 0.2~2KN.
ABB  PFTL 101AE-2.0KN 3BSE004213R1 Horizontal pillow tensimeter indenter is very suitable for small tension, roll weight and high running speed applications, metallurgy, steel, nonferrous, paper, metal deep processing and other industries often have many such applications PFTL 101AE-2.0KN 3BSE004213R1 is commonly used in conventional metal treatment lines. The indenter is suitable for applications with heavy rolls, wide tension ranges and high operating speeds.

ABB Tensiometer Millmate Strip tension measurement – Indenter measurement principle:
Piezomagnetic sensor is based on the principle that the magnetic permeability changes under the action of mechanical force. The sensor is made of a single piece of stainless steel with four holes punched in the stainless steel body. Through these four holes are wound two sets of coils, which are at an Angle to each other. When an alternating current is passed through the primary coil, a magnetic field is generated in the primary coil. Because the primary and secondary coils are at an Angle to each other, no magnetic field is generated in the secondary coil as long as there is no load on the sensor. When a mechanical force is applied to the measurement direction of the sensor, the magnetic field propagation direction in the primary coil changes, incorporating the secondary coil into the magnetic field. Because the magnetic field in the secondary coil changes, an induced potential is created in that coil. The control unit converts this induced potential into a DC voltage signal proportional to the measured force.

Wide measuring range: The measuring range is 40:1, the maximum is 200% of the rated range, the minimum is 5% of the rated range. Repeatable large overload capacity: 10 times the rated range of electrical overload capacity, more than 30 times the rated range of mechanical overload capacity, no plastic deformation and fatigue phenomenon. No calibration, no physical drift. High-power sensor output signal (100mV): large output signal and carrier frequency, excellent anti-interference performance. Low impedance output (10 ohms) : the indenter has better noise resistance, and the output signal is not sensitive to the insulation condition, which is more suitable for the harsh operating environment of the mill. Indenter protection level is IP65, which can operate normally in the field of splash.

ABB Tensimeter Millmate Strip Tension Measurement – System Applications:
1: Continuous annealing line – heating furnace part
2: Cold tandem rolling mill – inlet tensioning roll
3: Annealing – pickling line – steering roller
4: Sendzimir rolling mill
5: Rack cold tandem mill – middle rack

ABB Tensimeter Millmate Strip tension measurement system brings benefits to users
Improve product quality, reduce mill downtime caused by unpredictable faults, increase output and increase rolling speed.